Related Manuals for Kinderkraft I-360
Summary of Contents for Kinderkraft I-360
- Page 1 I-360 USER GUIDE MODEL: I-360 ECE R129.03 v.1.0 MODEL: I-GUARD ECE.R129.03 ver. 1.2...
-
Page 2: General Information
1.0 General information NOTE: The product graphics are for illustrative purposes only! The car seat has been designed, tested, and approved in accordance with the requirements of UN/ECE Regulation No. 129 concerning the approval of child restraint systems (UN/ECE R129/03). Do not position the car seat forward-facing until the child is 15 months old and 76 cm tall. - Page 3 Child’s height Car seat orientation Car seat installation ISOFIX + support leg + internal safety 40cm–105cm harness ISOFIX + support leg + internal safety 76cm-105cm harness ISOFIX + three-point car seat belt 100cm-150cm three-point car seat belt...
-
Page 4: Safety Instructions
2.0 Safety Instructions Please take a few minutes to read this instruction manual to ensure proper safety for your child. • DO NOT install the car seat on rearward facing or side- facing seats in the vehicle. • DO NOT place the car seat on seats equipped with an active front airbag. - Page 5 3.0 Securing the child 3.1 Installing the insert Use the additional insert until the child reaches 76 cm. 1. Connect the headrest part of the insert to the rest of the insert with the fasteners 2. Detach the safety harness 3.
-
Page 6: Adjusting The Safety Harness
3.2 Adjusting the safety harness Loosen the safety harness by pressing the button and pulling the safety harness all the way down at the same time. 1. Press the safety harness adjustment button while simultaneously pulling the safety harness to the limit. 2. -
Page 7: Headrest Height
3.3 Headrest height The headrest should be adjusted to the child's head well, the lower part of the headrest should be positioned at the child's shoulder height. 1. Grasp the headrest height adjustment strap, which is located on the top of the headrest, and pull it up gently 2. - Page 8 3.4 Backrest angle of incline adjustment mechanism 1. Pull the backrest angle of incline adjustment lever 2. Adjust the seat angle of incline 3. Release the lever in the required position (one of five available options) 4. Move the seat slightly until you hear a distinct "click" sound NOTE! It is possible to adjust the backrest angle of incline for children with a height of 76-105 cm.
- Page 9 3.5 Easy spin mechanism Easy spin mechanism is a function that helps you comfortably place or remove your child from the car seat. 1. Pull the car seat easy spin lever 2. Rotate the car seat to the side of your choice. You will hear a "click" indicating that the car seat is locked in the selected position 3.
- Page 10 3.6 Securing the child with the internal safety harness 1. Loosen the safety harness fully by pressing the button and pulling the harness straps 2. Unfasten the buckle 3. Place the safety harness on the sides of the car seat 4.
- Page 11 3.7 Tightening the safety harness 1. Pull the internal safety harness to eliminate the clearance in the waist section, the safety harness should lie flat. 2. Tighten the safety harness with the adjuster strap until the safety harness lies flat on the child's body. IMPORTANT! Make sure the safety harness is not twisted.
- Page 12 4.1.1 Installation using the ISOFIX system Before placing the car seat in the car, unfold the support leg. 1. Attach the ISOFIX pads to the seat connectors in the vehicle. 2. Place the car seat together with the unfolded support leg on the seat in the vehicle.
- Page 13 4.1.2 Installing the support leg 1. Pull the support leg of the car seat out of the base 2. Pull the upper part of the leg towards you 3. Fully unfold the leg until you hear a "click" 4. Press the leg height adjustment buttons on both sides of the leg (this will release the leg height lock, and the leg will automatically extend) 5.
- Page 14 • NOTE! The support leg must never be unsupported, and no objects can be placed under it. • IMPORTANT! The support leg shall support the car seat – it shall not lift the bottom part of the I-360 seat above the level of the seat of the vehicle.
- Page 15 4.2 Forward facing installation of the car seat for children between 76 and 105 cm using the ISOFIX system and the support leg. 1. Unfold the stabilizing leg- you will hear a "click" when unfolded. 2. Place the car seat on the seat of the vehicle 3.
- Page 16 4.3 Forward facing installation of the car seat for children between 100 and 150 cm using the three-point car seat belt. 1. Install the car seat on the seat of the vehicle using the ISOFIX connectors (forward-facing). 2. Push the car seat as far as possible into the seat and check for correct installation - the installation indicators should turn green.
- Page 17 5.0 Stowing away the five-point safety harness 1. Loosen the safety harness fully by pressing the button and pulling the safety harness. Remember: do not pull the shoulder pads. 2. Remove the shoulder pads and buckle pad by unfastening the fasteners 3.
- Page 18 5.1 Removing the car seat (ISOFIX system + support leg) 1. Fold the support leg extension by holding the two buttons on the sides of the leg extension and push it up by retracting it into the other part of the leg.
-
Page 19: Removing The Cover
5.2 Removing the cover 1. Remove the insert 2. Move the headrest to the highest position 3. Remove the shoulder pads and buckle pad 4. Unfasten four fasteners securing the cover to the front part of the car seat backrest and the fasteners on the sides of the car seat 5. - Page 20 • Do not use aggressive cleaning agents (such as solvents). • The safety harness can be cleaned in lukewarm soapy water. Warning! Metal snaps should never be removed from the safety harness. Full Warranty Terms and Conditions are available at WWW.KINDERKRAFT.COM...