Dos Modules; Connecting A Dos Module; Dispensing Liquids - Miele PG 8504 Operating Instructions Manual

Connecting a
DOS module
Dispensing liquids For adjusting dispensing concentration, see "Additional settings/Dis-
Adding and dispensing process chemicals

DOS modules

If required an additional external dispensing module (DOS module)
can be fitted retrospectively for liquid process chemicals.
External DOS modules are fitted by Miele Service or a qualified and
approved technician. Internal dispensing systems cannot be retro-
spectively fitted.
The DOS module is supplied with its own installation instructions.
 Before fitting the DOS module, compare the connection data
(voltage and frequency) on the data plate with that on the data
plate of your machine. If the data does not match, the module
could sustain damage. If in any doubt, consult an electrician.
 Power supply for DOS 1, process chemicals .
 Connection for dispensing hose.
Connect the module to the machine's power supply.

To connect the dispensing hose, release the hose clip on a free

connector and remove the safety cap.
Push the dispensing hose onto the connector and secure it with a

hose clip.
Unused connectors must be blanked off with safety caps to pre-
vent the leakage of wash fluid.
pensing systems".
47