Adding and dispensing chemical agents
Connecting a
DOS module
Dispensing liquids
48
DOS modules
If required an additional external dispensing module (DOS module)
can be fitted retrospectively for liquid chemical agents.
External DOS modules are fitted by Miele Service or a suitably
qualified and approved technician. Internal dispensing systems
cannot be retrospectively fitted.
The DOS module is supplied with its own installation instructions.
Power supply for DOS 1, cleaning agent.
Connection for dispensing hose.
Before fitting the DOS module compare the connection data
(voltage and frequency) on the data plate with that on the data
plate of your machine. If the data does not match, the module
could sustain damage. If in any doubt, consult an electrician.
Connect the module to the electricity supply.
To connect the dispensing hose, release the hose clip on a free
connector and remove the safety cap.
Push the dispensing hose onto the connector and secure it with a
hose clip.
Unused connectors must be blanked off with safety caps to
prevent the leakage of wash fluid.
For adjusting dispensing concentration see "Further settings /
Dispensing systems".