Dexter Laundry T-300 Operators Manual Installation & Operation Instructions page 96

COMM ERROR8
SECONDARY FUSE
ERROR
MAIN FUSE ERROR
DELAY
DRIVE STO
8514-300-001 REV PR
Solu on
VFD Condi on
Communica on
Fault
Delay
Ac on
Solu on
Factory program Condi on
error
Delay
Ac on
Solu on
Factory program Condi on
error
Delay
Ac on
Solu on
Communica on Condi on
loss
Delay
Ac on
Solu on
VFD Safety Condi on
Torque Off Error
Delay
Ac on
The washer will not restart un l the power is
removed and re-applied.
This error is caused when the VFD reports a
frequency value that is out of range
Delay me is 35 seconds
Stop the machine and clear the cycle. Keep the
door locked un l the machine has stopped
moving and then unlock the door.
The washer will not restart un l the power is
removed and re-applied.
This error occurs when the fuse se ngs for
the Slave/Secondary microprocessor have not
been set correctly during factory programming
None
When detected, the washer control shall not
be opera onal.
The control must be re-programmed with the
factory programming tool.
This error occurs when the fuse se ngs for
the Master/Main microprocessor have not
been set correctly during factory programming
None
When detected, the washer control shall not
be opera onal.
The control must be re-programmed with the
factory programming tool.
This is an intermediate error code that displays
as the control is a emp ng to re-establish
communica ons with the variable frequency
drive. It is a condi on of other specified Error
Codes (for example Comm Error6).
4 cycles of 10 seconds if during tumble por on
of cycle
4 cycles of 2 minutes if during spin por on of
cycle
Prompt is displayed during each of the specified
10 second or 2-minute periods. Error condi on
(such as Comm Error4) occurs, but Delay is
shown instead of specific Error Code. Ac on
during this me is dependent on the specific
error code that caused it.
None. Either communica on is re-established,
or the specific Error Code eventually occurs.
This error occurs when the drive detects an
open circuit in both the S1 and S2 to +24V drive
jumper connec ons.
Occurs following the "DELAY" error (see
corresponding detail)
Stop the machine and clear the cycle. Keep the
door locked un l the machine has stopped
moving and then unlock the door.
96