Table of Contents
Advertisement
Signal Switch between SBUS&PPM and PWM
Short press the binding button on the receiver twice within 1 second to switch the SBUS/PPM
signal to PWM signal.
1.3.2 Guide of Receiver Install
(1) Please test RSSI (Received Signal Strength Indicator) before operating models. For methods
on how to test it, please refer to
(2) If the antenna of the receiver is damaged, replace it with a new antenna or receiver in time.
(3) Keep antennas as straight as possible, or the effective control range will reduce. PS: Generally,
the receiver's antenna is longer than the body of drone, but also shouldn't break or shrink the
antenna into it.
(4) Big models may contain metal parts that influence signal emission. In this case, antennas
should be positioned at both sides of the model to ensure the best signal status in all
circumstances.
(5) Antennas should be kept away from metal conductor and carbon fiber at least half inch away
and no over bending.
(6) Keep antennas away from motor, ESC or other possible interference sources.
(7) Receiver contains some electronic components of high-precision. Be careful to avoid strong
vibration and high temperature.
(8) Special vibration-proof material for R/C like foam or rubber cloth is used to pack to protect
receiver. Keeping the receiver in a well-sealed plastic bag can avoid humidity and dust, which
would possibly make the receiver out of control. Putting the receiver into a plastic bag can
also prevent fuel and residue from entering.
1.3.3 Binding
T8S and R8EF have already finished binding by default. If you purchase a new compatible
receiver separately, you need to bind the receiver to the transmitter. Each receiver has an
individual ID code. When the binding is done, the ID code will be stored in the transmitter and
there's no need to rebind.
Binding steps:
① Put the transmitter and the receiver close to each other in parallel (about 50 centimeters).
② Push the Power Switch to power on T8S.
③ Power on the R8EF, the LED of R8EF will start flashing slowly.
④ There is a binding button(ID SET) on the side of receiver. Press the button until the LED
flashing quickly and release, binding process is ongoing.
⑤ When the LED stops flashing and turns to always on, binding is complete. If not succeed,
the LED will keep flashing slowly to notify, repeat the above steps.
Check the binding tutorial here:
https://www.radiolink.com/newsinfo/477894.html
https://www.youtube.com/watch?v=D2cwvloIMDM
8
Advertisement
Table of Contents
