Mig/Mag Program Sequence ("Program Steps" Mode); Selection Of The Program Sequence Parameter - EWM Taurus 301 Synergic Operating Instructions Manual

Design and function
MIG/MAG welding

5.8.13 MIG/MAG program sequence ("Program steps" mode)

Certain materials, such as aluminium, require special functions in order to be able to weld them safely
and at high quality. The latched special operating mode is used here with the following programs:
• Start program P
• Main program P
• Reduced main program P
• End program P
The programs include the parameters wire speed (operating point), arc length correction, slope times,
program duration, etc.
I
This function can only be enabled with the PC300.NET software.
• (See operating instructions for the software)

5.8.13.1 Selection of the program sequence parameter

Operating
Element
m/min
54
(reduction of cool points at the start of the seam)
START
(continuous welding)
A
(targeted heat reduction)
B
(minimisation of end craters via targeted heat reduction)
END)
P
START
P
Action Result
Select parameter in the program sequence
n x
Setting welding parameters
P
A A
P
B
Figure 5-23
NOTE
P
END
t
Display
099-005157-EW501
09.06.2011