BWT AQA stop Installation And Operating Manual page 12

EN
1 Safety instructions
1.1 General safety instructions
This product was manufactured according to all
recognised regulations and technical standards
and complied with the applicable legal requirements
when it was put into circulation.
Nevertheless, it can pose a risk of personal injury
or property damage if you do not observe this
chapter and the safety instructions throughout this
documentation.
● Read this documentation carefully and in its en-
tirety before working with the product.
● This documentation must be kept accessible to
all users at all times.
● Always hand over the product to third parties to-
gether with the full documentation.
● Follow all of the instructions in relation to the
proper handling of the product.
● If you detect damage to the product or the mains
supply, stop its operation and notify a service
technician immediately.
● Use only accessories, spare parts, and con-
sumable materials that have been approved by
BWT.
● Adhere to the environmental and operating con-
ditions specified in the "Technical Data" section.
● Use your personal protective equipment. It en-
sures your safety and protects you from injury.
● Only perform tasks that are described in these
operating instructions or if you have been
trained to do so by BWT.
● Perform all tasks in compliance with all applica-
ble standards and provisions.
● Instruct the operator in the function and opera-
tion of the product.
● Instruct the operator in the maintenance of the
product.
● Instruct the operator in relation to potential dan-
gers that may arise while operating the product.
12
1.2 Scope of the documentation
This documentation applies exclusively to the
product whose production number is listed on
the title page and in the "Technical data" section.
This documentation is intended for operators, end
users, fitters without training from BWT, fitters with
training from BWT (e.g. drinking water specialists),
and BWT service technicians.
This documentation contains important information
for fitting the product safely and properly, starting
up, operating, using, maintaining, and disassem-
bling the product, and for correcting simple faults
independently.
Read this documentation in full before working with
the product. Pay particular attention to the safety
instructions chapter.
1.3 Personnel qualifications
The installation work described in these instructions
requires basic knowledge of mechanics, hydraulics
and electrical systems as well as knowledge of the
corresponding specialist terms.
To ensure that the device is installed safely, this work
must be performed only by a qualified specialist or
a trained person under the guidance of a qualified
specialist.
A qualified specialist is anyone who can assess the
work assigned to him or her, identify potential risks,
and take suitable safety measures thanks to his or
her specialist training, knowledge, and experience
as well as his or her knowledge of the applicable
regulations. Specialists must comply with applica-
ble, industry-specific regulations.