Table of Contents
Advertisement
10. SOURCE
Select the input source mode.
11. RETURN
Step back in some menu options
12. MENU
Open the menu options. Step back in some menu options.
13.
Exit the current menu.
14.
Navigate the menu.
pq t
u
15. OK
Confirm the selection.
16. TEXT
Press to enter or exit the teletext menu.
17. SUBTITLE
Enable/disable subtitles in DTV/USB mode.
18. LIST
Press to enter into the channel list.
19. FAV
Press to view your assigned favourite list or main list channels. Press
press OK to confirm. To open the selected list directly, you can press the LIST button.
20. 20. COLOUR BUTTONS
Press to execute the prompt function in TV or DTV menu mode.
2.5 Installing the batteries
Place 2x AAA batteries in the battery compartment of the remote control. Make sure to match the polarity markings inside the compartment.
NOTE:
Pictures are only for reference. Actual items may differ.
1. Slide the cover horizontally.
2. Put 2x AAA batteries in the compartment and make sure the polarity is correct.
3. Slide horizontally to close the cover.
Precautions for using the battery
Improper using of the battery will cause leakage. Carefully follow these instructions.
1. Please note the batteries' polarity to avoid short circuit.
2. When the battery's voltage is insufficient which affect the use range, you should replace it with a new battery. Remove the batteries from the
remote control unit if you do not intend to use it for a long time.
3. Do not use different types of batteries (for example Manganese and Alkaline batteries) together.
4. Do not put the battery into fire, and charge or decompose the battery.
5. Please dispose batteries abide by relevant environmental protection regulation.
2.6 Using the remote control
Use the remote control by pointing it towards the remote sensor. Items between the remote control and the remote sensor could block normal
„
operation.
Do not cause the remote control to vibrate violently. Also, do not splash liquid on the remote control, also do not put the remote control in a
„
high humidity place.
Do not place the remote control under direct sunlight which will cause deformation of the unit by heat.
„
When the remote sensor is under direct sunlight or strong lighting, the remote control will not work. If so, please change the lighting or TV's
„
position, or operate the remote control closer to the remote sensor.
3.0 FIRST TIME INSTALLATION
After all connections have been properly made, switch on your TV. The language selection will appear on screen. Use
Language of your preference. Confirm with OK on your remote control.
The next screen appears with the Mode Selection to select Home Mode or Shop Mode. Press OK and
Then the next screen appears with the tuner selection. Choose the one you like to use.
Scan type
Select which input source you want to use: DVB-S to receive satellite broadcasts (and if you are equipped with a satellite dish),
DVB-T to receive terrestrial broadcasts or DVB-C to receive cable broadcasts.
3.1 DVB-S/S2 installation
Satellite Setting
First select the region where you are using the TV. This important to set time zone correct. Use the
to highlight the satellite your dish is aimed at. Confirm with OK to mark the satellite. Use the
Press
pq
satellite installation for each specific satellite. The signal quality bar on the bottom of the screen allows you to fine tune the alignment of your antenna
for optimum reception. Adjust your antenna for maximum possible signal quality. When the signal cannot be improved anymore, fix the dish on this
position and press the BLUE Scan button to continue.
Channel Search
to highlight the options of choice and press OK to start the channel search.
Press
pq t
u
Scan Mode
Choose between Default (recommended), Blind Scan, Network and Preset Channel List.*
to cycle through your assigned favourite channels,
pq
t
u
t
upq
5
to select the OSD
pq t
u
to confirm.
and confirm with OK.
buttons to change settings for your
t
upq
Fig. 5
Advertisement
Table of Contents
