Software Configuration
2. Data Bits.
3. Parity.
4. Stop Bits.
5. Flow Control.
6. Advanced - see the section below, titled "Advanced Port
Settings."
7. Restore Defaults - when clicked, resets the selected COM port
to the following values:
Baud Rate:
Data Bits:
Parity:
Stop Bits:
Flow Control:
Advanced Port Settings.
When the Advanced button of Port Settings in selected the
following dialogue is displayed:
Settings available in this window are:
1. FIFO settings.
• Use FIFO Buffers - turns the selected ports FIFO
• Receive Buffer - These settings allow the selection
Chapter 3 Page 22
buffer on or off. It is strongly recommended that the
FIFO for both ports is left enabled.
of a receiver FIFO trigger setting. Selecting a low
PCI Quad / Lynx 8 Port RS232
Change to suit remote device.
9600
8
None
1
Hardware