Gorenje GFACM20S Instruction Manual page 147

Clean the brewing system and frothing
system manually
1. Fill the water tank with an appropriate amount of room-
temperature water, but do not exceed the MAX water level.
Then, close the water tank lid.
2. Install the brewer assembly into the brewing chamber of
appliance and close the brewing chamber door.
3. Place the drip plate on the drip tray, and place a cup
(container) on the drip plate.
4. Activate the "Manual clean" function to clean the brewing
system and the milk frothing channel. After preheating, all
functional indicators will be constantly lit, and the appliance
enters the standby mode. Press the Manual clean key "
and hold it for at least 0.2 second. The appliance will enter
the manual clean mode.
NOTE: If the milk-frothing channel has to be cleaned,
please install the milk tank and fill the milk tank with some
clean water instead of milk. If the milk-frothing channel does
not require cleaning, please tightly close the milk frother
plug.
5. After cleaning, the appliance automatically enters the
standby mode.
6. Open the brewing chamber door and clean the coffee
grounds in the brewing system with a brush.
Removing mineral deposits
1. The appliance has to be descaled when the indicators
of Hot water " "and Manual clean "
time.
2. Fill the water tank with water and descaler to the MAX level
as indicated on the water tank (the ratio of water to descaler
is 4:1; for details, please refer to the instructions for the
descaler; please use a "household descaler"). You may also
use the citric acid instead of the descaler (one hundred
parts of water to three parts of citric acid).
3. Place a container (cup) on the drip plate.
4. Simultaneously press the Hot water key "
Manual clean key " " and hold them for 1 second. The
appliance starts the descaling process.
5. The whole descaling procedure lasts about 10 minutes. The
eight (8) functional indicators flash slowly from left to right.
6. After the descaling is completed, the Hot water "
Manual clean " " indicators stop flashing.
NOTE: When descaling is complete, the counter for coffee
brewing cycles will be reset to zero, and it will restart
counting. The descaling prompt will pop up when the
appliance has brewed a total of 500 cycles of coffee again.
25
147
"
" flash at the same
"and the
" and