Fans; Heat Sink - HP ZBOOK STUDIO 16 G10 Maintenance And Service Manual

Fans

To remove the fans, use this procedure and illustration.
Table 5-6 Fans description and part number
Description
Fan Kit (includes left and right fans, captive screws, and cables)
Before removing the fans, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the fans:
1. Release the webcam cable from the retention clips (1) that are built into the right fans.
2. Disconnect the fan cables (2) from the system board.
3. Loosen the four Phillips captive screws (3) that secure the fans to the computer.
4. Remove the fans (4).
To install the fans, reverse the removal procedure.

Heat sink

To remove the heat sink, use these procedures and illustrations.
Table 5-7 Heat sink descriptions and part numbers
Description
Heat sink (includes captive screws and replacement thermal material):
For use with system boards equipped with a graphics subsystem with discrete memory and an Intel
i-9 or Intel i-8 processor
Preparation for disassembly on page
Bottom cover on page 40).
Spare part number
N10924-001
Battery on page 46).
Spare part number
N10927-001
40).
Fans 49