Removal And Replacement Procedures For Authorized Service Provider Parts; Component Replacement Procedures; Preparation For Disassembly; Bottom Cover - HP ZBOOK STUDIO 16 G10 Maintenance And Service Manual

5 Removal and replacement procedures for
authorized service provider parts
This chapter provides removal and replacement procedures for authorized service provider parts.
IMPORTANT:
chapter. Accessing these parts can damage the computer or void the warranty.
NOTE: Details about your computer, including model, serial number, product key, and length of
warranty, are on the service tag at the bottom of your computer.

Component replacement procedures

To remove and replace computer components, use these procedures.
NOTE: HP continually improves and changes product parts. For complete and current information
about supported parts for your computer, go to http://partsurfer.hp.com, select your country or region,
and then follow the on-screen instructions.
You must remove, replace, or loosen as many as 65 screws when you service the parts described in this
chapter. Make special note of each screw size and location during removal and replacement.

Preparation for disassembly

To remove and replace computer components, use these procedures.
See Removal and replacement procedures preliminary requirements on page 31
procedures.
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.

Bottom cover

To remove the bottom cover, use this procedure and illustration.
40 Chapter 5 Removal and replacement procedures for authorized service provider parts
Only an authorized service provider should access the components described in this
for initial safety