Touchpad - HP ZBOOK STUDIO 16 G10 Maintenance And Service Manual

3. Remove the solid-state drive (see
4. Remove the battery (see
5. Remove the fans (see
6. Remove the heat sink (see
7. Remove the system board (see
Remove the touchpad cable:
1. Release the ZIF connector (1) the touchpad cable is connected to, and then disconnect the
touchpad cable from the transfer board.
2. Release the ZIF connector (2) the touchpad cable is connected to, and then disconnect the
touchpad cable from the touchpad.
3. Detach the touchpad cable (3) from the computer. The touchpad cable is attached to the computer
with double-sided adhesive.
4. Remove the touchpad cable.
To install the touchpad cable, reverse the removal procedure.

Touchpad

To remove the touchpad, use this procedure and illustration.
Table 5-12 Touchpad description and part number
Description
Touchpad
NOTE: The touchpad spare part kit does not include the touchpad cable. The touchpad cable is
available using spare part number N10935-001.
Before removing the touchpad, follow these steps:
72 Chapter 5 Removal and replacement procedures for authorized service provider parts
Solid-state drive on page
Battery on page 46).
Fans on page 49).
Heat sink on page 49).
System board on page
42).
62).
Spare part number
N10923-001