Fingerprint Reader - HP ZBOOK STUDIO 16 G10 Maintenance And Service Manual

4. Remove the battery (see
5. Remove the fans (see
6. Remove the heat sink (see
7. Remove the system board (see
Remove the fingerprint reader cable:
1. Release the ZIF connector (1) the fingerprint reader cable is connected to, and then disconnect the
fingerprint reader cable from the fingerprint reader.
2. Release the ZIF connector (2) the fingerprint reader cable is connected to, and then disconnect the
fingerprint reader cable from the transfer board.
3. Detach the fingerprint reader cable (3) from the computer. The fingerprint reader cable is attached
to the computer with double-sided adhesive.
4. Remove the fingerprint reader cable.
To install the fingerprint reader cable, reverse the removal procedure.

Fingerprint reader

To remove the fingerprint reader, use this procedure and illustration.
Table 5-10 Fingerprint reader description and part number
Description
Fingerprint reader
NOTE: The fingerprint reader spare part kit does not include the fingerprint reader bracket or the
fingerprint reader cable. The fingerprint reader bracket is included in the Bracket Kit, spare part
number N10940-001. The fingerprint reader cable is included in the Cable Kit, spare part number
N10935-001.
Before removing the fingerprint reader, follow these steps:
1. Prepare the computer for disassembly (see
68 Chapter 5 Removal and replacement procedures for authorized service provider parts
Battery on page 46).
Fans on page 49).
Heat sink on page 49).
System board on page
Preparation for disassembly on page
62).
Spare part number
N10920-001
40).