Leica Flexacam i5 User Manual page 41

Operation in Network Mode (Continued)
Connection to the mobile device
First connection:
1. Run the Flexacam in a stand-alone mode
(page 35).
2. Go to the network settings in the Enersight
OSD software as follows:
Enersight OSD Ú Settings Ú Network
3. Activate WebSocket and create the certifi-
cate.
4. Restart the Flexacam.
Perform step 4. only once during the
initial setup.
5. Download Enersight Mobile App on your
smartphone or tablet from Google Play or
App Store (see page 39).
Flexacam User Manual
To connect your mobile device (smartphone
or tablet), you can choose between 2 different
modes:
Flexacam serves as an Access Point (AP).
O
Flexacam is connected to a network – client
O
mode:
Your Flexacam serves as an Access Point
(AP):
1. Activate this mode on Enersight OSD as
:
follows
Settings Ú Network Ú AP-Mode
You will see the credentials of this AP (SSID,
password, etc.) and the IP address of the
device.
2. Connect your mobile device to this AP (via
Settings on your smartphone / tablet).
Operation (Network mode)
Your Flexacam is connected to a network –
client mode:
1. Activate this mode on Enersight OSD as
follows:
Settings Ú Network Ú Client-Mode
2. Select a network you would like to connect.
3. Enter the network password.
4. Connect your mobile device to the same
network.
In "Settings" on the Enersight OSD software
you will see an IP adress of your camera.
41