Xinje XSA330-W User Manual page 41

a. Press the "Del" key to enter the CMOS hard disk parameter setting, check if the boot
sequence are correct.
b. After booting with optical disk drive or floppy disk drive, check whether the hard disk has
a boot system or whether the hard disk is partitioned normally and has activated the boot
partition.
c. Press F8 during startup to select the last correct configuration to start the operating system.
d. Replace the hard disk with a new one and reinstall the system.
Q2: System crashes or blue screen during operation
(1) Check whether the controller temperature is too high.
(2) Check whether the wrong or expired driver is installed.
(3) Check whether the system is infected with viruses.
(4) Whether the system files, applications and disks are damaged.
Q3: The device driver could not be installed correctly
(1) Check whether the driver is correct and up to date.
(2) Whether the driver needs the support of the patch of the operating system.
(3) Whether the resources occupied by other devices conflict with the resources occupied by the
devices to be driven.
(4) If it is a peripheral device, replace a slot and reinstall the driver.
(5) Replace the device and reinstall the driver.
Q4: BIOS updating method
(1) Prepare a UEFI startup flash disk. If not, make one.
(2) Please copy the required BIOS files and batch processing to the root directory of the USB drive.
(3) Start up, press F7, select the prepared UEFI flash disk, enter, and enter the shell.
(4) Enter FS0: Enter (if no other storage device is connected, it is fs0:).
(5) Run flash.nsh, update the BIOS, and power off is not allowed in the process.
(6) After updating the BIOS, power off, then power on, restart the controller, enter BIOS settings, and
press F3 to load the BIOS optimized defaults (press Enter to select Y).
Q5: Notice
The following conditions may cause a refresh failure and fail to boot.
(1) Power failure during refreshing.
(2) There is a virus in the flash disk.
(3) BIOS file is damaged.
(4) Non UEFI system.
In case of failure to boot after refreshing, you can try to clear the BIOS. If the situation persists, please
return to the factory for maintenance.