Table of Contents
Advertisement
Electrical
Specific Precautions/Power Source
Turning Power ON/OFF
IMPORTANT:
Re-starting
TCA34R Series Changer Operation Instructions
The Tire Changer is manufactured to operate at a specific voltage and amperage
rating.
Make sure that the appropriate electrical supply circuit is of the same voltage and
amperage ratings as marked on the Tire Changer.
WARNING: DO NOT ALTER THE ELECTRICAL PLUG. Plugging the
electrical plug into an unsuitable supply circuit will
damage the equipment.
Make sure that the electrical supply circuit and the appropriate receptacle is installed
with proper grounding.
To prevent the possibility of electrical shock injury or damage to the equipment when
servicing the Tire Changer, power must be disconnected by removing the power cord
from the electrical power outlet.
After servicing, be sure the Tire Changer ON/OFF switch is in the "O" (off) position
before plugging the power cord into the electrical power outlet.
The Tire Changer is intended to operate from a power source that will apply 208-
230VAC, 1 phase, 15 amp 50/60 Hz, power cable includes NEMA 20 amp plug, L6-
20P, between the supply conductors of the power cord. The power cord supplied
utilizes a twist lock connector, NEMA L6-20P. This machine must be connected to a
20 amp branch circuit. Please refer all power source issues to a certified electrician.
Refer to "Installation Instructions for Tire Changer.
CAUTION:
A protective ground connection, through the grounding
conductor in the power cord, is essential for safe operation.
Use only a power cord that is in good condition.
The ON/OFF switch is located on the back of the Tire Changer. To turn the Tire
Changer "ON," press the "I" side of the ON/OFF switch. To turn the Tire Changer
"OFF," press the "O" side of the ON/OFF switch.
After turning on the Tire Changer the user must wait 30 seconds for the
motor controller to "learn" the position of the rotation pedal before operating
the tire changer.
If a rotation issue is encountered, re-start the tire changer using the following
procedure:
1. Switch the tire changer power switch to the "off" position.
Getting Started • • • • 5
Advertisement
Table of Contents
