Reset Position; Tire Inflation - Hunter TCA34R Series Operation Instructions Manual

Reset position

2.8 Tire Inflation

NOZZLE IS NOT
HORIZONTAL
TCA34R Series Changer Operation Instructions
To modify tool memorization, act the up/down command buttons to set a new tool head
position.
Keep the memorization button pressed until it turns off.
As soon as the button light turns on, the new position has been memorized.
Verify that the wheel has been properly clamped and centered.
Remove the valve stem core from valve stem. Removing the valve stem core will
allow the tire to inflate faster and the bead to seat easier.
Connect inflator hose to valve stem.
NOTE: To increase the effectiveness blast inflation nozzle, always
liberally lubricate the outer edge of the tire sidewall and pull
up on the tire while twisting to seal the bead.
Press the bead blaster hose on the wheel rim as shown below. Ensure the hose head
is pressed in.
NOTE: The nozzle should be horizontal for optimal performance.
INCORRECT
CORRECT
NOZZLE IS NOT
HORIZONTAL
NOZZLE IS
HORIZONTAL
INCORRECT
Basic Procedures • • • • 27