To Prevent The Outdoor Unit From Falling Over; Mounting The Indoor Unit; About Mounting The Indoor Unit - Daikin ETSHB16P30EF Installer's Reference Manual

7.3.8 To prevent the outdoor unit from falling over

7.4 Mounting the indoor unit

7.4.1 About mounting the indoor unit

EPRA14~18DAV3+W1 + ETSH/X(B)16P30+50EF
Daikin Altherma 3 H HT ECH₂O
4P679467-1 – 2022.02
In case the unit is installed in places where strong wind can tilt the unit, take
following measure:
1 Prepare 2 cables as indicated in the following illustration (field supply).
2 Place the 2 cables over the outdoor unit.
3 Insert a rubber sheet between the cables and the outdoor unit to prevent the
cables from scratching the paint (field supply).
4 Attach the ends of the cables.
5 Tighten the cables.
NOTICE
Discharge grille. Do NOT use too much force to prevent damage to the discharge
grille.
Typical workflow
Mounting the indoor unit typically consists of the following stages:
1 Installing the indoor unit.
7
|
5
6
Unit installation
Installer reference guide
83