Basic Scanning - Microtek ArtixScan DI 3130c Start Here Manual

Basic Scanning

1. Load the document to be scanned into the document feed tray of the scanner.
WARNING: Do not place photo paper or fragile sheets of paper on the feed tray, as doing this
will damage the original photo or frail papers during the feeding process.
2. Launch ScanWizard DI as a stand-alone program by clicking on the ScanWizard DI icon
on the desktop.
3. Click the Scan Setup button in the interface to activate the Scan Setup interface.
4. In the Scan Setup interface, follow the steps below to specify your basic settings.
a) Select ADF (Front Side), ADF (Back Side) or ADF (Duplex)
in the Scan Source drop-down menu as your image input
device.
b) Select the appropriate image type in the Color Mode as
your image output type.
Select RGB Color (24 bits) to scan the image in color.
–
– Select Grayscale (8 bits) to scan the image in
grayscale.
Select Black & White (1 bit) to scan the image in black-and-white.
–
– Select Auto Color Detection to scan the image in color or non-color based on
the automatic judgement and detection of the system.
– Select Complex to scan the image in color, grayscale or non-color based on the
customization. Refer to the "The Scan Setup Interface" section in the back for
how to customize a desired image output type.
c) Select a dimension in the Paper Size as your preview
image size.
d) Select a desired resolution in the Resolution for your
image output resolution.
e) If necessary, select "Text Orientation Recognition" in the
Rotate menu to ensure the scanned images in a readable
orientation. When it is selected, you can select the
preferred language used as an identification in the options
menu.
f) If "Auto-crop" & "Auto-deskew" is selected, the
scanner automatically detects the size of the original
image, crops the full scan frame to fit the image,
and removes unwanted black borders after the scan,
as well as corrects the distorted image for proper
alignment.
6