Indicator
To enable or disable the LED indicator, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Indicator.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select OFF (disabled) or ON (enabled).
7. Press <ENTER>.
Flash if DMX
To set the whether the LED indicator flashes when the fixture is connected to or disconnected from the
DMX, follow the instructions below:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Flash if DMX.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select ON (LED indicator flashes when fixture is connected to the DMX)
or OFF (LED indicator flashes when fixture is disconnected to the DMX).
7. Press <ENTER>.
Follow Spot Mode
To enable fixtures to be controlled via ILS command, follow the instructions below:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Follow Spot.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select ON (enables Follow Spot mode) or OFF (disables follow spot mode).
7. Press <ENTER>.
Reset
To reset all functions on the Intimidator Spot 160 ILS, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Reset.
5. Press <ENTER>.
Factory Reset
To restore the Intimidator Spot 160 ILS to factory default settings, follow the instructions below:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Factory Set.
5. Press <ENTER>.
System Information
To view the system information on the Intimidator Spot 160 ILS, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Sys Info.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Ver (displays the firmware version), Running Mode (displays the
current running mode), DMX Address (displays the current DMX address), Temperature
(displays the product temperature in °C), or DFI (displays connected D-Fi, if available).
12
Intimidator Spot 160 ILS User Manual Rev. 2
Operation