Table of Contents
Advertisement
Adding and dispensing chemical agents
Refill indicator
Dispensing
rinsing agent
54
Add rinsing agent only until it is up to the "max." mark on the edge
of the funnel.
Close the container.
Wipe up any spilled rinsing agent. This prevents over-foaming
occurring during the next programme.
When the fill level is low in the (DOS 2) supply container for rinsing
agent you are reminded to refill it.
Confirm the message shown with OK and
refill the rinsing agent as described.
The dispensing concentration is set by the Miele Customer Service
Department.
- If there are spots of water left on load items after reprocessing, then
the dispensing concentration is set too low.
- If clouding or smearing appears on load items, the dispensing
concentration is set too high.
In either case contact the Miele Customer Service Department and
have the dispensing concentration reset.
Refill rinsing agent
Advertisement
Table of Contents
