Hyundai Kona Hybrid 2023 Owner's Manual page 111

Securing a Child Restraint System
with a lap/shoulder belt
When not using the ISOFIX system, all
Child Restraint Systems must be secured
to a rear seat using the lap/shoulder belt.
2C_ALRSeatBeltInstall
Installing a Child Restraint System with a
lap/shoulder belt
To install a Child Restraint System on the
rear seats:
1. Place the Child Restraint System on a
rear seat and route the lap/shoulder
belt around or through the Child
Restraint System, following the Child
Restraint System manufacturer's
instructions. Make sure the seat belt
webbing is not twisted.
2. Fasten the lap/shoulder belt latch into
the buckle. Listen for the distinct "click"
sound.
2C_ALRSeatBeltInstall_2
Information
Position the release button so that it is
easy to access in an emergency.
2C_ALRSeatBeltInstall_5
3. Remove as much slack from the belt as
possible by pushing down on the Child
Restraint System while feeding the
shoulder belt back into the retractor.
4. Push and pull on the Child Restraint
System to confirm that the seat belt is
holding it firmly in place.
If your Child Restraint System
manufacturer instructs or recommends
you to use a top tether anchorage with
the lap/shoulder belt, refer to "Securing a
Child Restraint System seat with Top
Tether Anchorage system" section for
more information.
To remove the Child Restraint System,
press the release button on the buckle
and then pull the seat belt out of the Child
Restraint System and allow the seat belt
to retract fully.
3
3-43