Adjustments; Adjusting The Height-Adjustable Support - probst RG-100-SAFELOCK Operating Instructions Manual

Adjustments

5 Adjustments
Caution while adjustment work. There is danger of injuring the hands!
Use safety gloves! →
5.1

Adjusting the height-adjustable support

The height-adjustable support is set as follows:
1. Measuring the outer diameter of the pipe in cm
2. Pull the spring bolt (A) upwards and turn it by 180° (Fig. 1)
3. Move rectangular tube (B) until the correct immersion depth is set
(see window)
4. Pull the spring bolt (A) upwards again and turn it by 180
5. Push the rectangular tube (B) back and forth until the spring bolt
engages in the corresponding hole.
The setting of the height-adjustable support must be adjusted
equally on both sides of the unit. Otherwise the gripping
material will hang at an angle during the lifting process and
there is a danger of the gripping material slipping off. Danger
of accident!
The height-adjustable support must always be set so that the
gripper jaws always grip the concrete pipe below the centre!
Otherwise there is a danger of slipping!
54500008
12 / 23
V4
A
Fig. 1
B
GB