Adjustments; Adjustment Of The Gripping Range - probst RG-20/80 Operating Instructions Manual

Adjustments

5 Adjustments
5.1

Adjustment of the gripping range

5.1.1 Adjustment of the gripping range
By adjusting the gripping range, the device (RG-20/80) is suitable for different sizes of gripping goods (concrete
tubes).
Before the product can be lifted and transported, the gripping range has to be adjusted to the dimensions of
the product.
•
The adjustment of the gripping range may never take place on both sides at the same time.
Always adjust the gripping range first to the one and then on the other side.
•
Pull the spring bolt upwards and rotate around 180°.
•
Move the rectangular tube, until the gripping range is approx. 5 cm larger than the product.
•
Pull the spring bolt back up again and rotate around 180°.
•
Move the rectangular tube so long until the spring bolt engages in one of the holes.
•
The adjustment of the gripping range has to follow general symmetrical.
That means, it must be used in each case the same adjustable hole with both rectangular tubes.
•
Caution while adjusting of the gripping range.
There is a danger of injuring the hands!
•
Caution while adjustment work. There is danger of injuring the hands!
Use safety gloves! →
54500002
Rectangular tube with adjustable holes
13 / 21
Automatic release
Spring bolt
GB