Installing the system board
Steps
1. Align the system board into its slot on the computer chassis.
2. Install the screws that secure the system board to the computer.
3. Connect the power supply and display cables to their connectors.
4. Connect the following cables:
a. System board cable
b. Display power supply cable
c. Display connector cable
5. Install the:
a.
display assembly
b.
system fan
c.
WLAN card
d.
heat sink
e.
SSD bracket
f.
SSD
g.
system fan
h.
battery
i.
back cover
6. Follow the procedure in
Removing the display assembly
Steps
1. Follow the procedure in
NOTE:
If you have purchased the touch version of this computer, you will not be able to further disassemble the display.
Instead the entire display assembly needs to be replaced.
2. Remove the:
a.
back cover
b.
battery
c.
WLAN card
3. To remove the display hinges:
a. Lift the tab to disconnect the display cables from the system board [1] [2].
b. Unroute the display cable from around the system fan [3] [4].
After working inside your computer
Before working inside your
computer.
Disassembly and reassembly
35