Configuring The Hard Drive Type; Configuring Hard Drive Groups (Advanced) - FLIR DNR110 Series Instruction Manual

14 Using the Main Menu
3. Click OK to save changes. The system will restart to complete the formatting process.

14.3.18 Configuring the Hard Drive Type

The system supports the following hard drive types:
• Read-write HDD: Normal recording hard drive.
• Read-only HDD: The system can playback data from this hard drive, but it will not re-
cord to it.
To set the hard drive type:
1. From the Main Menu, click
2. Click the hard drive you would like to configure.
3. Under Type, select Read-write HDD or Read-only HDD.
4. Click OK to save changes. The system will restart to complete this operation.

14.3.19 Configuring Hard Drive Groups (Advanced)

Hard drive groups allow you to balance recordings across multiple hard drives. For exam-
ple, you can record channels 1~4 to one hard drive and 4~8 to a second hard drive. This
can reduce the amount of wear on the hard drives and may extend the life of the hard
drives.
NOTE
• Two hard drives must be installed in the system to use hard drive groups, and both hard drives must
be formatted as Read-write hard drives. For details on installing hard drives, see 14.3.18 Configuring
the Hard Drive Type.
To configure hard drive groups:
1. From the Main Menu, click
Setting.
#LX400068; r. 1.0/27398/27398; en-US
and then click Storage>HDD Manager.
and then click Storage>HDD Advance>HDD
65