ICON PRO-FORM SPORT POWER STACK XT User Manual page 26

CONVERTING THE ARMS
To use the Arms (9, 10) as press arms, insert the two
Arm Pins (40) into the holes in the Pivot Frame (5)
9 A
40 3
and into the holes in the Arms as shown.
To use the Arms (9, 10) as butterfly arms, insert the
40
two Arm Pins (40) into the holes (A) in the Upper
Upright (3).
5
10
ATTACHING THE ACCESSORIES
55
35
Attach the Lat Bar (35) to the High Cable (55) at the
high pulley station with a Cable Clip (37).
37
For some exercises, attach the Chain (83) between
the Lat Bar (35) and the High Cable (55) with two
37
Cable Clips (37). Adjust the length of the Chain
between the Lat Bar and the High Cable so that
the Lat Bar is in the correct starting position for
83
the exercise to be performed.
The Lat Bar (35) or the Handle Strap (80) can be
attached at either pulley station in the same way.
80
Always engage the Lock Plate (not shown) when
using the low pulley station (see USING THE LEG
LEVER below).
USING THE LEG LEVER
To use the Leg Lever (8), pull the Leg Lever Pin (38)
out of the Leg Lever and the Lock Plate (73).
To use the low pulley station, insert the Leg Lever
Pin (38) fully into the Leg Lever (8) and the Lock
38
Plate (73).
8
73
26