ICON PRO-FORM SPORT POWER STACK XT User Manual page 21

31. Thread an M12 Nut (13) all of the way onto the
end of the High Cable (55).
Next, place a Large Washer (17) on top of the
Weight Selector (24).
Tighten the High Cable (55) into the Weight
Selector (24) until all of the slack is removed
from the cables.
Then, tighten the M12 Nut (13) against the Large
Washer (17).
Tip: If the High Cable (55) does not reach
to the Weight Selector (24), see step 25. If
more than two threads of the Low Cable (53)
are showing above the M6 Locknut (33), adjust
the Locknut so that only two threads of the Low
Cable are showing.
Seat Assembly
32. Attach the Backrest (16) to the Lower Upright
(20) with two M6 x 65mm Screws (70) and two
M6 Washers (82).
33. Attach the Seat (15) to the Seat Frame (6) with
four M6 x 16mm Screws (62).
31
32
16
33
15
6
21
55
13
17
24
70
82
20
70
82
62