ICON PRO-FORM SPORT POWER STACK XT User Manual page 14

12. Apply grease to an M10 x 77mm Bolt (79).
Orient the Pivot Frame (5) so that the welded
pins (G) are on the side shown. Attach the
Pivot Frame to the Top Frame (4) with the
M10 x 77mm Bolt (79) and an M10 Locknut (56).
Do not overtighten the Locknut; the Pivot
Frame must pivot easily.
Next, attach the two Arm Pins (40) to the Pivot
Frame (5) with two M4 x 19mm Self-tapping
Screws (69).
Insert the Arm Pins (40) into the two holes (H) in
the Upper Upright (3).
13. Apply grease to an M8 x 50mm Shoulder
Bolt (66).
Attach a Cable Pivot (39) to the Left Arm (10)
with the M8 x 50mm Shoulder Bolt (66) and an
M8 Locknut (58).
Next, wet the inside of a Large Foam Pad (42)
with soapy water. Slide the Large Foam Pad
onto the Left Arm (10).
Then, attach a Handle (11) to the Left Arm (10)
with two M10 x 25mm Screws (77) and two M10
Washers (57).
Assemble the Right Arm (9) in the same way.
12
56
5
69
Grease
40
G
13
9
14
4
H
79
3
69
40
66
Grease
39
10
58
42
11
57
77