Status Led Overview; For Ecdis Calibrated Products - Hatteland HM 19T14 User Manual

Status LED Overview

Status LED Overview
The unit features a multi purpose indicator LED status ring which through different patterns. Realtime
activity gives back the status of the signal detected, power on/off, calibration, menu activity and more.
The LEDs are multicolored which either illuminate green, red or orange, based on the activity.
OFF (No power connected)
8 LED OFF
ON (Signal OK)
8 GREEN LED STATIC ON
OFF (Shutdown)
1 RED LED MOVES for 3 sec. After additional
3 secs, all leds turns RED.
* Alarm / Buzzer notes:
1: Can operate either as visible Alarm LED, or visible Alam LED + Audible Buzzer Sound.
2: Alarm / Buzzer function can be activated through SCOM (Serial Remote Control) or via Multifunction Cable (RS-232) with applied 12VDC.
3: Please review http://www.hatteland-display.com/pdflink/inb100018-3.php
"Pin Assignments - Multifunction Cable Outputs" chapter in this manual for more information.

For ECDIS Calibrated Products

For units that are ECDIS calibrated from factory, the following LED pattern (Calibrated) indicates that the
backlight/brightness is at calibrated level. (Calibrated +) or (Calibrated -) means that the
brightness adjustment value is above or below the calibrated brightness level. Fine adjust the brightness
in terms of decreasing or increasing the value until the pattern for (Calibrated) is reached.
ON (Calibrated)
4 GREEN LED STATIC ON
Operation
IND100064-31
OFF (Standby, power detected)
8 RED LED STATIC ON
ON (No Signal)
4 RED LED STATIC ON
ALARM / Buzzer*
or
4 ORANGE LED STATIC ON
Turned on when command is activated or external
12VDC is applied.
(internet / own manual) and
ON (Calibrated +)
4 GREEN LED STATIC ON + where 1 show
BRIGHTNESS INDICATION POSITION
22
ON (Signal Search)
1 GREEN LED MOVEMENT looping.
ON (Menu Delay)
7 GREEN LED STATIC +
1 LED OFF MOVEMENT doing 1 loop.
ON (Calibrated -)
4 GREEN LED STATIC ON + where 1 show
BRIGHTNESS INDICATION POSITION