Roland VS-2480 User Manual page 56

Using Effects
7.
As described in "Selecting the effect bus assignment (p. 52)," specify
which AUX bus will be used as the effect bus. Here we will send the AUX1
signal to the Effect 1 (FX 1).
fig.04-08_30
RATIO
THRESHOLD ATTACK
Dynamics
PHRASE SEQ
/ AUTOMIX
8 MANUAL
WRITE
READ
FROM
TO
TRACK
REC
PLAY
OFF
1 2 3
PHRASE
PAD
17 18 19
(dB)
R 6
4
0
4
8
12
18
24
42
L
8.
Press [CH EDIT] for the track mixer channel whose effect you wish to use.
For this example, press channel 2 [CH EDIT]. Mixer Condition screen will
appear.
9.
Output the signal to AUX 1. Use [
cursor to the AUX1 Send switch, use the TIME/VALUE dial to set the send
switch to a setting other than Off.
10. Use [
][
fader, use TIME/VALUE dial to adjust the effect send level. Normally, you
will leave the AUX1 channel fader at the 0 dB position.
11. Press [HOME (DISPLAY)]. Home Condition screen will appear.
12. Press [TR 17-24/FX RTN (V.FADER)]. [TR 17-24/FX RTN (V.FADER)]
indicator will light, channel fader will adjust the Track Mixer channel 17–24
and the Effect 1–8 Return level.
fig.tr-chview
13. Raise and lower the FX1RTN fader.
The effect depth will change. Adjust
to the desired depth.
14. Begin the recording, following the
procedure described in "Recording
On a Track (p. 36) step 11–14."
15. When you finish recording, press
[STOP].
16. As described in "Playing Back the Demo Performance (p. 28)," record a
performance and then listen to it.
56
PAN / AUX SEND 1-8
RELEASE LEVEL FREQ GAIN FREQ GAIN FREQ Q GAIN
Filter EQ Low EQ Lo - Mid
CH EDIT / SELECT / PHRASE SEQ STATUS / AUTOMIX STATUS
TRACK STATUS / PHRASE PAD
4 5 6 7 8 9 10 11 12
AUX 2 AUX 3 AUX 4
AUX1 MST
20 21 22 23 24
FX1 FX 2 FX 3 FX 4
RTN
13
][
][ ][ ] to move the cursor to the AUX1 channel
AUX PHRASE
SEND PAD PLAY
PRM PHRASE
FREQ Q GAIN FREQ
EDIT SEQ
EQ High
EQ Hi - Mid
IN 1-16 IN 17-24
AUX MST
SOLO MUTE
TR 1-16 TR 17-24
FX RTN 12
V.FADER
MASTER
EDIT
13 14 15 16
FADER
AUX 5 AUX 6 AUX 7 AUX 8
MASTER
FX 5 FX 6 FX 7 FX 8
(dB)
6 R
4
0
4
8
12
18
24
42
L
][ ][ ] to move the
At this time, the sound of
input mixer channel 1 will
no longer be output
directly from master out,
and will be routed through
the track mixer.
By applying an effect to the
track mixer, you can apply
effects without modifying
the input signal.