Basic Connections (Power Supply, Audio Devices And Headphones) - Roland VS-2480 User Manual

Preparations
fig.battery3_69
7.
Reinstall the effect expansion board (VS8F-2) if removed in Step 5. Insert
the plastic pin in the VS8F-2's hole, making sure the board is securely
fastened in place.
8.
Use the screws that you removed in step 2 to fasten the cover back in place.
This completes the process of exchanging the lithium battery.
9.
Connect the cables that you disconnected earlier.
10. Turn on the power, as described in "Turning On the Power (p. 19)."
11. Confirm that the message warning that the lithium battery is depleted does
not appear in the display.
12. Set the current time (p. 22).
Basic Connections (Power Supply, Audio
Devices and Headphones)
fig.01-11j_60
POWER
ON
AC IN
To Power Outlet
If you are using headphones, connect them to the rear panel PHONES 1 or PHONES
2 jack. The PHONES jack will output the same signal as the MONITOR jacks.
When you purchase the VS-2480/2480CD, it will be set so that all analog audio
signals are output from the MASTER jacks. The MONITOR jacks will output the
same sound as the MASTER jacks.
fig.01-12
18
ANALOG MULTI OUTPUT
PS / 2 MIDI
THIS DEVICE COMPLIES WITH PART 15 OF SMPTE FOOT
THE FCC RULES. OPERATION IS SUBJECT IN KEYBOARD MOUSE OUT / THRU IN SWITCH PHONES 2 PHONES 1 8 7
TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY
CAUSE UNDESIRED OPERATION.
R L
MONITOR
SCSI VGA OUT 2
WORD CLOCK IN
DIGITAL 8ch I / O DIGITAL 8ch I / O
Stereo Headphones
(RH-25, RH-50, etc.)
Ground (Earth)
+4dBu BALANCED / -2dBu UNBALANCED
6 5 4 3 2 1
GND COLD
(SLEEVE) (RING)
HOT
(TIP)
R L R L R L
AUX B AUX A MASTER
DIGITAL
1 OUT IN
OUT IN
COAXIAL
OPTICAL
Stereo Set, etc.
A CR2032 lithium battery is
used for the
VS-2480/2480CD. This type
of battery is available at an
electric appliance, or
similar store.
The internal clock is
powered by the lithium
battery. Changing the
lithium battery may cause
this clock to stop, or may
result in the current time
being altered. Always
make sure to newly set the
correct time after the
lithium battery has been
replaced.
For details refer to Owner's
Manual "Working with the
VS-2480 Output. (p. 287)"