Applying A Loop Type Effect Only To The Monitor Sound As You Record - Roland VS-2480 User Manual

Applying a Loop Type Effect Only to the
Monitor Sound as You Record
The following example shows how a source connected to the INPUT 1 jack can be
recorded on track 2 directly (without effects) while you apply a send/return type
effect such as reverb or delay to the monitor sound. This is convenient when you
wish to hear a reverb (FX1) on a vocal (for example) as you record, but would like to
try out various reverb settings during playback.
fig.04-06_55
1.
Press [HOME (DISPLAY)]. Home Condition will appear.
fig.push-in1-16
2.
Press [IN 1-16 (SOLO)]. [IN 1-16 (SOLO)] indicator will
light, channel fader will adjust the Input Mixer channel 1–16.
3.
Raise and lower the channel fader 1, and verify that the
volume changes. The Input Mixer channel fader is used to
make fine adjustments to the recording level. In order to
record with optimal audio quality, the fader should normally be set in the 0
dB position.
fig.04-08_30
TO
TRACK
REC
PLAY
OFF
1 2 3 4
PHRASE
PAD
17 18 19 20
(dB)
R 6
4
0
4
8
12
18
24
42
L
3
fig.04-08_30
4.
Press [TR 1-16 (MASTER EDIT)]. [TR 1-16 (MASTER EDIT)] indicator will
light, and [CH EDIT] will be the Track Mixer channel edit buttons for
channels 1–16.
5.
Hold [REC] and press [TRACK STATUS] of
the track that you wish to record. For this
example, hold [REC] and press the track 2
[TRACK STATUS]. [TRACK STATUS] will
blink red.
6.
As described in "Recording On a Track (p. 36)" step 6–9, specify which
you wish to assign as the source. For this example, Input Mixer channel 1 is
assigned to the recording track 2.
F1 F2 F3 F4 F5
PAGE
TRACK STATUS / PHRASE PAD
5 6 7 8 9 10 11 12
AUX 2 AUX 3 AUX 4 AUX 5 AUX 6 AUX 7 AUX 8
AUX1
MST
21 22 23 24
FX1 FX 2 FX 3 FX 4
RTN
DISPLAY
F6
HOME
1
IN 1-16 IN 17-24
AUX MST
SOLO MUTE
TR 1-16 TR 17-24
FX RTN
V.FADER
MASTER
EDIT
FADER
TR 1-16 TR 17-24
4
FX RTN
V.FADER
MASTER
EDIT
13 14 15 16
FADER
MASTER
FX 5 FX 6 FX 7 FX 8
(dB)
6 R
4
0
4
8
12
18
24
42
L
REC
+
2
AUTOMIX REC
Using Effects
Time is displayed at
present on the right of the
Home Condition screen in
the initial state. In addition
to the remaining time, the
display can also be
switched to remaining
capacity (MB units,
percentage (%), or event
units).
55