Naming A Pattern [Name] - Roland V-Drums TD-8 Owner's Manual

Chapter 5 Playing Along with Patterns
6. Press [INC/+] or [DEC/-] or rotate the VALUE dial to
specify.
7. Press [F3 (EXEC)].
The confirmation screen appears.
fig.06-061
8. Again, press [F3 (EXEC)].
Press [F1 (CANCEL)] to cancel the operation.
PART: PART1, PART2, PART3, PART4, KIT,
PERC, ALL
This selects the part from which data is to be erased.
When "ALL" is selected, then all part performance data
is erased.
MEASURE: ALL, First Measure-Last Measure
ALL:
This erases all measures.
First Measure: 1–99
This specifies the measure at which erasing is to begin.
Last Measure: 1–99
This specifies the measure at which erasing is to end.
For example, to erase all the performance data in all
parts from Measure 4 to the end of Measure 6, specify as
shown below.
fig.06-065
118

Naming a Pattern [NAME]

Each pattern can be given a name of up to 8 characters.
fig.06-067.e
Press [SHIFT]
1. Follow the procedures described in "Choosing a Pattern"
(p. 97) to select the pattern to be named.
2. Press [PATTERN], then [F3 (
[PATTERN] lights, and a pop-up menu appears
3. Press [INC/+] or [DEC/-], rotate the VALUE dial, or
press CURSOR [ ] or [
"NAME."
4. Press [F3] to confirm your choice.
The "PATTERN EDIT" screen appears.
5. Press CURSOR [F1 (LEFT
move the cursor to the character to be changed.
6. Press [INC/+] or [DEC/-], rotate the VALUE dial, or
press CURSOR [ ] or [
7. Press [EXIT] to finish.
[F1(LEFT )]
Move the cursor to the left.
[F2(RIGHT )]
Move the cursor to the right.
[F3(CHAR)]
Cycle between uppercase and symbols.
[SHIFT] + [F1 (INSERT)]
A blank space is inserted at the cursor position, and the
characters after the insertion are moved back one space.
[SHIFT] + [F2 (DELETE)]
The character at the cursor position is deleted, and the
characters after the deletion are moved forward one
space.
MENU)].
] to move the cursor to
)] or [F2 (RIGHT )] to
] to change the character.