Deleting An Unneeded Pattern [Delete]; Transposing A Pattern [Transpose] - Roland V-Drums TD-8 Owner's Manual

1. Follow the instructions in "Choosing a Song" (p. 121) to
select the song in which the pattern is to be inserted.
2. Press [SONG], then [REC].
[SONG] and [REC] light, and the "SONG REC" screen
appears.
3. Press CURSOR [
] or [
the pattern is to be inserted.
fig.07-008
4. Press [F1 (INSERT)].
The step is inserted at the cursor position, and later steps
are each moved back one place.
fig.07-009
5. Press [INC/+] or [DEC/-] or rotate the VALUE dial to
select pattern.
6. Press [EXIT] to finish.
The [REC] light is turned out.
Deleting an Unneeded Pattern
[DELETE]
This operation deletes a pattern from a song. When a pattern
is deleted, subsequent patterns will be moved forward.
fig.07-010
1 2 3 4
1 3 4 5
1. Follow the instructions in "Choosing a Song" (p. 121) to
select the song from which the pattern is to be deleted.
2. Press [SONG], then [REC].
[SONG] and [REC] light, and the "SONG REC" screen
appears.
3. Press CURSOR [
] or [
which the pattern is to be deleted.
fig.07-011
] to select the step in which
5 6
6
] to select the step from
Chapter 6 Playing Along with Songs
4. Press [F2 (DELETE)].
The step at the cursor position is deleted, and later steps
are each moved forward one place.
fig.07-012
5. Press [EXIT] to finish.
The [REC] light is turned out.
Transposing a Pattern
[TRANSPOSE]
This transposes patterns recorded in a song. Adding the
transpose value set in the registered pattern (p. 102) sets only
the one to be transposed.
fig.07-012a
Song setting
fig.07-013
1. Follow the instructions in "Choosing a Song" (p. 121) to
select the song to be set.
2. Press [SONG], then [REC].
[SONG] and [REC] light, and the "SONG REC" screen
appears.
3. Press CURSOR [
] or [
pattern to be transposed.
4. Press [F3 (TRANS)].
The cursor moves to the transpose value.
Press [F3 (PTN)] to restore the cursor position.
5. Press [INC/+] or [DEC/-] or rotate the VALUE dial to
make the setting.
6. Press [EXIT] to finish.
The [REC] light is turned out.
TRANSPOSE BIAS: -24–+24
Patten setting
+4
+7
+3
] to select the step with the
125