Dc Offset Voltage Setting - UNI-T UTG1000 Series User Manual

3. Select required unit: Press unit softkeymVpp.
Note: This parameter can be set by multifunctional knob and direction buttons.

3.3.3 DC Offset Voltage Setting

The default waveform is a sine wave with 0V DC offset voltage (with 50Ω termination).Steps for changing DC offset
voltage to -150mV are shown as following:
1.
Press Menu→Waveform→Parameter→Offsetto enter parameter setting.
2. Use number keys to input the required number of -150.
3.
Select corresponding unit mV.
Note: This parameter can be set by multifunctional knob and direction buttons.
UTG1000A Series 17