Table of Contents
Advertisement
Hardware Installation and Reference Guide
6.2.4
LED Is Steady Green
The device performs initialization after power-on. During this period, the LED keeps steady green and does not
turn normal blue until the initialization is completed. Note: If the steady green persists for an hour, the device
initialization fails and the device is faulty.
6.2.5
LED Blinks Green at an Interval of 0.2s for a Long Time
Sometimes the AP performs software upgrade after power-on. During this period, the LED keeps blinking green
at an interval of 0.2s and enters the normal state of quick off after blinking green until the upgrade is completed.
Note: Do not plug or unplug the power cord when the LED is blinking as software upgrade takes time. If the
blinking persists for 10 minutes, the device fails to complete software upgrade and is faulty.
6.2.6
LED Blinks Red at an Interval of 1s for a Long Time
If the LED blinks red at an interval of 1s after the system starts, the AP probably has not established a proper
CAPWAP connection with the AC. Verify that the AC is operational and configured properly.
6.2.7
No Wireless Signal Searched
(1) Verify that the device is properly powered.
(2) Verify that the Ethernet port is correctly connected.
(3) Verify that the AP is correctly configured.
(4) Move the client device to adjust the distance between the client and the AP.
26
Troubleshooting
Advertisement
Table of Contents
Need help?
Do you have a question about the RG-AP180-I and is the answer not in the manual?
Questions and answers