Kemppi FastMig SF 51 Operating Manual page 11

Auto Wire Inch
Demo Licence Time
Restore Factory
Settings
Setup-parameters for MMA welding
Name of parameter
Start Power
Device Address
Code Entry
Restore Factory
Settings
Arc Voltage Display function needs activation.
NOTE!
© Kemppi Oy / 1515
AIn OFF, on on
dEt 3-h, 2-h, **' ,
**'' , OFF
FAC OFF, PAn, OFF
ALL
Name on Parameter
display values
StA -9 ... +9
Add 3 or 6
Cod ---, Ent
FAC OFF, PAn, ALL
SuperSnake Automatic Wire Inch function. Wire Inch
button runs the filler wire from the wire feeder up to the
SuperSnake.
The remaining time for the WiseDemo licence
(readable value only).
3-h = max. 3 hours left
2-h = max. 2 hours left
**' = ** minutes left
**'' = ** seconds left
OFF = Demo period has expired.
Control panel reset function.
OFF = No reset
PAn = Settings will be restored, but memory channels
remain unchanged
ALL = All settings will be restored to factory values.
Factory
Description
setting
0 Strength of start pulse
3 Wire feeder bus address
Entering license codes manually:
1. Adjust right potentiometer to ('Ent').
2. Press REMOTE.
3. Set code with right potentiometer.
---
4. Choose next with left potentiometer.
5. Go back to point 3, until all codes have
been set.
6. Approve by pressing REMOTE. ('Suc cEs')
Control panel reset function.
OFF = No reset
PAn = Settings will be restored, but
OFF
memory channels remain unchanged
ALL = All settings will be restored to
factory values
EN
9