Read these sections carefully and follow their instructions. product introduction HiArc S 140 is a manual metal arc welding machine, small in size, suitable for industry, site and repair welding. The unit uses one phase connection voltage (230 V).
Mains cable and wall plug are already installed. parts of the unit Body of machine Main power switch Selector switch for welding process Welding current regulator Signal light, machine 'ON' Signal light for overheating Electrode holder and welding cable Earth return cable and clamp Hiarc S 140...
Check that welding cable and earth return cable connections are tight. If a connection is slack, it will result in voltage drop that will cause the connection to heat. Mount the electrode firmly in holder. Hiarc S 140...
A yellow signal light of overheating is lit, when thermostat has tripped due to the unit’s overheating. Fan will cool the unit and after the signal light goes off, the unit is again ready for welding. Hiarc S 140...
• Check tightness of welding and earth return cable connections. • Check condition of mains and welding cables and replace damaged cables. • See that there is enough space in front of and back of the unit for ventilation. Hiarc S 140...
The owner of the equipment is obliged to deliver a decommissioned unit to a regional collection centre, per the instructions of local authorities or a Kemppi representative. By applying this European Directive you will improve the environment and human health.