SMC Networks ZSE10(F) Operation Manual page 7

●Product handling
∗Installation
•Tighten to the specified tightening torque.
If the tightening torque is exceeded the mounting screws and brackets may be broken.
If the tightening torque is insufficient, the product can be displaced and loosen the mounting screws.
(Refer to "Mounting and Installation" on page 15.)
•Do not apply excessive stress to the product when it is mounted with a panel mount.
Otherwise damage to the product and disconnection from the panel mount can result.
•Be sure to ground terminal FG when using a commercially available switch-mode power supply.
•Do not drop, hit or apply shock to the Pressure switch.
Otherwise damage to the internal parts can result, causing malfunction.
•Do not pull the lead wire forcefully, not lift the product by pulling the lead wire. (Tensile force 35 N or less)
Hold the body when handling to avoid the damage of the Pressure switch which lead to cause the failure and
malfunction.
•For piping of the Pressure switch, hold the piping with a spanner on the metal part of the piping (Piping
attachment).
Holding other part with spanner leads to damage the Pressure switch.
•The tightening torque of piping must be 1 N•m for M5 (This is equivalent to approximate 1/6 extra
tightening after manual tightening.) and 7 to 9 N•m for R1/8 and NPT1/8.
Exceeding this value can damage the piping.
•For piping of the Pressure switch, hold the piping with a spanner on the metal part of the piping
(Piping attachment).
Holding other part with spanner leads to damage the Pressure switch.
•Eliminate any dust left in the piping by air blow before connecting the piping to the product.
Otherwise it can cause damage or malfunction.
•Do not insert metal wires or other foreign matter into the pressure measurement port.
It can damage the pressure sensor causing failure or malfunction.
-6-
No.PS※※-OMM0005-J