Table of Contents
Advertisement
Rotation: Select the monitor, and set the rotation as 0°, 90°, 180° and 270° in the bottom of the
interface. Click "OK" to confirm. As shown in the figure below:
Note: select any 1 out of the 4 outputs which are connected to the same EXT extension interface.
Right click the monitor can also rotate the monitor.
Output Area Size Setting: Move the mouse to the output area and slide the mouse wheel, the output
area size can be zoom in and out
Adjust Layer: Two ways can change the size and location of the opened layer:
a. Drag the opened layer by mouse. The details are: move the mouse to the brink of the opened layer,
when the mouse shows"<—>", press the left key of the mouse and drag the window to a suitable size
and then release the mouse. Or move the mouse to the lower right of the opened layer, press the left
key of the mouse and drag the window to a suitable size and then release the mouse. Move the
mouse to the opened layer and press the left key of the mouse and move the mouse, then the layer
will be moved, release the mouse when moved to the suitable location. But this method can only
adjust the size and location roughly, if an accurate adjustment is needed, the second method can be
used.
b. Select the layer to be adjusted, and set the X, Y, width and height in the bottom of the interface.
Hiera
rchic
FLEX 16
User Manual
35
Advertisement
Table of Contents
