RGBlink FLEX 16 User Manual page 16

SAVE
If the IN→OUT (matrix) setting need to be saved, press button SAVE , LCD will show
instruction as below
At this time, press any button among 1-16 in IN area, it means save to the corresponding
position of 1-16,press any button among 1-16 in OUT area, it means save to the
corresponding position of 17-32. i.e., press button 2 in IN area means save to SAVE 2,
press button 2 in OUT area, means save to SAVE18.
LOAD
If the saved setting need to be recalled,press button LOAD，LCD will show as below
The buttons keep illuminating indicates that these SAVE are available and the latest
saved position flashes. .i.e there are in 2 position SAVE 2 and SAVE 18 in sequence,.
Button 2 in IN area keep illuminating and button 2 in OUT area flashes.
POWER-STAND BY MODE
Press button POWER LCD shows the indication as follow:
In stand by mode, press POWER for 3S, all buttons flashes one by one immediately and
LCD shows
5S later, the device goes back to work and in the status before stand by.
FLEX 16
SAVE TO:_
LOAD FROM：_
ENTER STANDBY MODE
YES<ENTER>,NO<MENU>
RGBLINK
FLEX 16
User Manual
15