Operation - EIP HGR1500 User Manual

The fan draws the moist air through the refrigerated surfaces which cools it
below its dew point, removing moisture which is collected and lead away. The
cool air then passes over the hot condenser, where it is repeated. With the
addition of other radiated heat the air is discharged into the room at a higher
temperature but a lower relative humidity than when it entered the unit.
Continuous circulation of the room air through the dehumidifier unit gradually
reduces the relative humidity in the room.
The HGR1500 dehumidifier is a robust, compact unit designed to control the
humidity in the enclosed space in which it is placed.
The unit is thermally protected and will switch off for a period if maximum
operating temperature of 40ºC is exceeded.
WARNING THIS APPLIANCE MUST BE EARTHED
WIRING:
Connect the power mains cable/plug of the dehumidifier unit as follows:-
As the colour of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminal in your own
plug, proceed as follows.
The wire which is coloured Green and Yellow must be connected to the
terminal marked E or by the Earth symbol or coloured Green or Green and
Yellow. The wire which is coloured Blue must be connected to the terminal in
the plug which is marked the letters N or coloured Black. The wire which is
coloured Brown must be connected to the terminal which is marked with the
letter L or coloured Red.
You must safely dispose of the non re-wireable plug once it has been
removed from the flexible cord. It is dangerous to attempt to insert the plug
into any electrical socket.
CHANGING THE FUSE
13 Amp fuses that are ASTA approved to BS1362 should only be used.
NON REWIREABLE PLUGS
The fuse cover must be refitted after the replacement of the fuse.

OPERATION

ELECTRICAL CONNECTIONS
Brown
Blue
Green/Yellow
Page 4 of 12
Drawing : - TPC413
Issue : - 1
Date : - 22/01/14
Live
Neutral
Earth (ground)