Page 2
Drawing : - TPC262 Issue : - 5 Date : - 05/01/12 UNPACKING Carefully remove the CD100 dehumidifier unit from its transit box and visually check for signs of transit damage. If there is evidence of damage DO NOT attempt to operate the unit, call your supplier for advice. Do not discard the packing;...
Drawing : - TPC262 Issue : - 5 Date : - 05/01/12 INSTALLATION POSITIONING: Position the dehumidifier unit in the center of the room to be conditioned if at all possible. However if a damp patch is particularly apparent the outlet grille should be pointed towards it.
Drawing : - TPC262 Issue : - 5 Date : - 05/01/12 OPERATION The operation of the dehumidifier is to remove moisture from the air by having it condense on the cool tubes of the evaporator coil. The air then passes over the hot condenser and returns to the conditioned space slightly warmer and at reduced moisture content.
Drawing : - TPC262 Issue : - 5 Date : - 05/01/12 WARNING: • Due to the high pressures within the refrigeration circuit, under no circumstances must direct heat be applied to the evaporator coil in an attempt to remove the build up of ice. •...
SPECIAL FEATURES HEATED CONDENSATE DRAINAGE TUBE: The CD100E dehumidifier is fitted with a heater tape which runs the length of the condensate tube. The effect of this heated condensate drainage tube will ensure that the drainage point for the dehumidifier is kept free from ice when operated in low ambients.
Drawing : - TPC262 Issue : - 5 Date : - 05/01/12 ROUTINE MAINTENANCE WARNING: ENSURE THAT THE POWER CORD TO THE MACHINE HAS BEEN DISCONNECTED BEFORE CARRYING OUT ROUTINE MAINTENACE ON ITEMS 1, 2, 3, 4, AND 5. To ensure continued full efficiency of the dehumidifier, maintenance procedures should be performed as follows: Clean the surface of the evaporator and condenser coils by blowing the dirt out from behind the fins with compressed air.
Page 9
Drawing : - TPC262 Issue : - 5 Date : - 05/01/12 REPAIRS Should an electrical component fail, consult the Factory Service Center to obtain the proper replacement part. If refrigerant gas is lost from the machine, it will be necessary to use a refrigeration technician to correct the fault.
Drawing : - TPC262 Issue : - 5 Date : - 05/01/12 TROUBLESHOOTING YMPTOM AUSE EMEDY Unit inoperative 1. Check the power supply 1. No power to unit (no red light) and fuse 1. Tighten fan 1. Loose fan on shaft 2.
Page 11
Drawing : - TPC262 Issue : - 5 Date : - 05/01/12 CD100E SPARE PARTS LIST Part Description Number 1600500 DEFROST TIMER CAPILLIARY TUBE .047 2 pcs. 3014251 48” Per 3014338 UNREINFORCED PVC TUBE 3020116 COMPRESSOR 3020727 CONDENSER COIL 3020732...
Wall Mounted Bracket. 8. Using Item 6 assemble items 1 and 2 ensuring the fingers of Item 2 locate into the CD100 chassis. 9. Secure the CD100 / CD100E with the 2 Claw Clamps onto Item 1. Page 13 of 16...
Drawing : - TPC262 Issue : - 5 Date : - 05/01/12 LIMITED WARRANTY Our products carry a one-year unconditional warranty against any defects in workmanship or material. This warranty will cover all parts and labor required to repair your Ebac product. This warranty is invalid if the unit has been abused, damaged, whether intentional or accidental, or if any modifications have been made to the unit.
Page 15
Drawing : - TPC262 Issue : - 5 Date : - 05/01/12 Page 15 of 16...