Page 1
Drawing : - TPC226 Issue : - 5 Date : - 05/01/12 CD30 / CD30E INDUSTRIAL DEHUMIDIFIER OWNER’S MANUAL www.eipl.co.uk Page 1 of 8 Product Support Questions: Contact Ebac USA at (757) 873 6800 Sales Inquiries: Contact Sylvane at (800) 934-9194 or visit sylvane.com...
Page 2
The unit incorporates a welded steel chassis and is finished in an epoxy coating for resilience to damage caused by rough handling. The CD30 dehumidifier is fitted with an adjustable humidistat to enable you to select the level of dryness.
TEST FOR CORRECT OPERATION The following procedures should be followed to test the CD30 for correct operation. 1. After unpacking, examine all external features to confirm damage free shipment.
Drawing : - TPC226 Issue : - 5 Date : - 05/01/12 ROUTINE MAINTENANCE WARNING: ENSURE THAT THE POWER CORD TO THE MACHINE HAS BEEN DISCONNECTED BEFORE CARRYING OUT ROUTINE MAINTENACE ON ITEMS 1, 2, 3, AND 4. To ensure continued full efficiency of the dehumidifier, maintenance procedures should be performed as follows: Clean the surface of the evaporator and condenser coils by blowing the dirt out from behind the fins with compressed air.
Page 6
Drawing : - TPC226 Issue : - 5 Date : - 05/01/12 REPAIRS Should an electrical component fail, consult the Factory Service Center to obtain the proper replacement part. If refrigerant gas is lost from the machine, it will be necessary to use a refrigeration technician to correct the fault.
Drawing : - TPC226 Issue : - 5 Date : - 05/01/12 TROUBLESHOOTING YMPTOM AUSE EMEDY 1. Check the power from the Unit inoperative 1. No power to unit power supply panel. 1. Tighten fan 1. Loose fan on shaft 2.
Need help?
Do you have a question about the CD30 and is the answer not in the manual?
Questions and answers