Supermicro X13SAZ-F User Manual page 96

Super X13SAZ-F/Q User's Manual
P1_NVME0 OPROM
Use this feature to select which firmware type to be loaded for the add-on card in this slot.
The options are Disabled and EFI.
Onboard LAN Option ROM
Use this feature to select which firmware function to be loaded for LAN 1 used for system
boot. The options are Disabled and EFI.
SATA And RST Configuration

SATA Controller(s)
Use this feature to enable or disable the onboard SATA controller supported by the Intel PCH
chip. The options are Enabled and Disabled.
Storage Option ROM/UEFI Driver
Select UEFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for
system boot. The options are Do not Launch and EFI.
Aggressive LPM Support
When this feature is set to Enabled, the SATA AHCI controller manages the power usage of
the SATA link. The controller will put the link in a low power mode during extended periods of
I/O inactivity and will return the link to an active state when I/O activity resumes. The options
are Disabled and Enabled.
I-SATA0 - I-SATA3
This feature displays the information detected on the installed SATA drive on the particular
SATA port.
•
Software Preserve Support
Hot Plug
Set this feature to Enable for hot plug support, which allows you to replace a SATA drive
without shutting down the system. The options are Disabled and Enabled.
Spin Up Device
Set this feature to enable or disable the PCH to initialize the device. The options are
Disabled and Enabled.
SATA Device Type
Use this feature to specify if the SATA port should be connected to a Solid State Drive or
a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive.
96