Battery Removal And Installation; Battery Removal; Proper Battery Disposal; Battery Installation - Supermicro X13SAZ-F User Manual

Super X13SAZ-F/Q User's Manual

3.4 Battery Removal and Installation

Battery Removal

To remove the battery, follow the steps below:
1. Power off your system and unplug your power cable.
2. Remove the battery cable at the J18 connector on the board.
3. Remove the battery.

Proper Battery Disposal

Please handle used batteries carefully. Do not damage the battery in any way; a damaged
battery may release hazardous materials into the environment. Do not discard a used battery
in the garbage or a public landfill. Please comply with the regulations set up by your local
hazardous waste management agency to dispose of your used battery properly.

Battery Installation

1. Unplug the power cord.
2. Connect the battery cable into the battery connector (J18) and push it down until you
hear a click to ensure that the cable is securely locked.
3. The battery is temporarily placed on the heatsink during shipping. Please use the foam
tape on the back side of the battery to secure the battery to a flat surface on the bottom
of the motherboard or a proper location in the system. DO NOT place the battery on the
heatsink during operation.
72