Supermicro X13SAZ-F User Manual page 79

Power Configuration
Watch Dog Function
If enabled, the Watch Dog Timer will allow the system to reset or generate NMI based on
jumper settings when it is expired for more than five minutes. The options are Disabled and
Enabled.
AC Loss Power Depend On
Use this feature to set the power state after a power outage. Select Stay Off for the system
power to remain off after a power loss. Select Power On for the system power to be turned
on after a power loss. Select Last State to allow the system to resume its last power state
before a power loss. The options are Stay Off, Power On, and Last State.
Power Button Function
This feature controls how the system shuts down when the power button is pressed. Select
4 Seconds Override to power off the system after pressing and holding the power button for
four seconds or longer. Select Instant Off to instantly power off the system as soon as the
user presses the power button. The options are Instant Off and 4 Seconds Override.
DeepSx Power Policies
Use this feature to configure the Advanced Configuration and Power Interface (ACPI) settings
for the system. Enable S4 to use Hibernation mode (Suspend to Disk) so that all data stored in
the main memory can be saved in a non-volatile memory area such as in a hard drive and then
power down the system. Enable S5 to power off the whole system except the power supply
unit (PSU) and keep the power button alive so that you can wake up the system by using a
USB keyboard or mouse. The options are Disabled, Enabled In S4-S5, and Enabled in S5.
CPU Configuration

The following CPU information will display:
•
CPU Signature
•
Microcode Patch
•
Max CPU Speed
•
Min CPU Speed
•
CPU Speed
•
Number of Performance-cores
•
Number of Efficient-cores
79
Chapter 4: BIOS