Exec Mode Commands - Lantronix SESPM1040-541-LT Series Operation Manual

Lantronix

Exec Mode Commands

When you first access the CLI, the system is in Exec mode and the command prompt displays as
?
At the prompt enter a
SESPM1040# ?
! Comments
clear Reset functions
configure Enter configuration mode
copy Restore system configuration
debug Enter debug mode
end end
exit Exit from the CLI
firmware firmware
history Display the current session's command line history
logout Logout of the current CLI session
ping Send ICMP frame to network host to verify network connectivity and
host availability
reload Reload system
show Show running system information
top Return to the default mode
SESPM1040#
At the command prompt enter a <tab> to display the available commands in a mode in the format below:
SESPM1040# <tab>
! clear
history logout
top
SESPM1040#
Command: ? (help)
Description: Enter a question mark (?) in the command line to display the commands / parameters
available in the current mode. You can also enter a <tab> to display the available commands in
table format.
Syntax : ?
Parameters: <cr>
Mode: All command modes.
Example 1: Enter a single question mark (?) in the command line to display the commands available in a list.
SESPM1040# show ?
ble
clock
community-names
default-config
dhcp
dio
dmi
dns
firmware
https
33773 Rev. F
and hit the Enter key to display the commands supported in the current mode.
configure copy
ping reload
BLE commands
Set clock options
show community names
Contents of default configuration
DHCP Server
Digital IO configuration
Show DMI Information
show dns
firmware
Show HTTPS information
https://www.lantronix.com/
SESPM1040-541-LT-xx Operation Guide
debug end
show
SESPM1040#
exit firmware
Page 19 of 228
.